1. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH

2. DISCONNECT SKID CONTROL SENSOR WIRE

(a) Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm.

3. DISCONNECT STEERING KNUCKLE LH

(a) Support the front suspension lower arm LH with a jack.

(b) Remove the clip and the nut.

(c) Using SST, disconnect the upper ball joint from the steering knuckle. SST: 09628-62011

4. REMOVE FRONT FENDER APRON SEAL LH

(a) Using a clip remover, remove the 6 clips and apron seal.

5. REMOVE FRONT FENDER APRON SEAL REAR LH

(a) Using a clip remover, remove the 5 clips and apron seal.

6. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY

(a) Remove the nut, bolt, 2 washers and suspension upper arm.